RJ-45 Connection

I’m looking for a schematic that will aid me into getting my network to recognize that there is a connection. So far I can trick the connection by connecting wirers 1 and 3 or 2 and 6 out of the eight wires. I don’t need a connection to a true network of any sort, but by a way to trick the connection with some sort of filter or transformer of any kind. What I’ve done so far was connect wires 1 and 3 together using a relay. This connection works fine; however after hundred thousand on/off the relay in particular takes a dump! Down below is your typical wiring pattern. 1 TX+ 2 TX- 3 RX+ 4 not used 5 not used 6 RX- 7 not used 8 not used Any suggestions or a list of materials would be appreciated; however a small schematic is what I’m looking for. ## Deliverables 1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done. 2) Deliverables must be in ready-to-run condition, as follows (depending on the nature of the deliverables): a) For web sites or other server-side deliverables intended to only ever exist in one place in the Buyer's environment--Deliverables must be installed by the Seller in ready-to-run condition in the Buyer's environment. b) For all others including desktop software or software the buyer intends to distribute: A software installation package that will install the software in ready-to-run condition on the platform(s) specified in this bid request. 3) All deliverables will be considered "work made for hire" under U.S. Copyright law. Buyer will receive exclusive and complete copyrights to all work purchased. (No GPL, GNU, 3rd party components, etc. unless all copyright ramifications are explained AND AGREED TO by the buyer on the site per the coder's Seller Legal Agreement). ## Platform Hardware