Arduino Shield ver 2

For the second board, we can start with the first. -We can remove all of the external power (12-14v) and power these components from the Arduino 5v (it might be smart to power the sensors from the 5v pins next to D22/23) -Keep the 5 screw terminals for the ds18b20 sensors -Keep 2 thermistor terminals (2 screws) -Keep 2 of the 5v-Gnd-Data sensors (6 screws total) -Keep 2 interrupts (2 screws) -Keep 2 voltage dividers -Keep 1 extra 5v and 1 extra Gnd screw terminals -19 total screw terminals all to be placed on the Power/Analog side of the Arduino Shield -Keep all of the connections for the Neo-6m, LSM303, and 2x HC-05 chips as they are wired in PCM1. -Add a header for a 20x4 LCD connection. (image attached- I am using this wiring) -Add three buttons that will trigger page changes and other inputs on the LCD (5v, Gnd, and connect each to any unused Data pin through resistors) -Add a 5k potentiometer in the LCD wiring as shown above